Lifts CH-3-3 in Front Leveling Lift Kit That is compatible with Chevy/Gmc Pickup

Used these to allow me to fit 33s with no rub and so far has been a huge change in the truck for the money and the ride quality is still good.

Got the truck sitting good and level

Awesome heavy duty spacer. Super easy to install. Truck looks amazing and it lifted it up a good bit. Highly recommend.

The kit was good quality with the exception of the finish. It was already flaked off in a few areas but not a huge deal. Most of the spacer is hidden up in the pocket.Installation was pretty straight forward and the instructions were pretty helpful, with one mistake for the socket sizes given. It takes a deep 17mm to tighten the nylock nuts from the spacer to the strut. Again, no biggie. But he rest were right on the money.I originally put a 2" spacer kit, that installed under the strut. It sat a little bit higher in the front, so I put in 2" blocks in the back to compensate for it and it had a much bigger rake again. Yucko!So out with the 2" and in with the 3".Made a noticeable difference! The truck sits perfectly! It took me approximately 2.5hrs to install. Including the removal of the 2" kit.One tip, loosen both sway bar bolts/nuts on both sides. It makes the lower control arm sag/flex much easier. And a stubby Allen wrench in the bottom of the upper ball joint, to keep it from spinning while tightening.Also, most trucks used the factory studs on the top of the strut towers for wiring bundle securing. You'll have to secure it yourself after the installation, because there isn't enough thread sticking through, to reuse them on the new hardware.I'd give it 5 stars, if the coating was better but it's a good kit that's reasonably priced.I'm running 285/70-17 Nitto Terra Grapplers on 17" Fuel Mavericks and it looks beefy.

This 3" Motofab front leveling kit did exactly what it stated it would do and I am very happy with the end result. No more stock Raked Stance and a more aggressive look on my 2018 Z71 Silverado. I highly recommend this kit.

Fit good fairly easy install 2-3 hrs. Rides very stiff (2WD) I removed sway bar and rides like stock with the front end a tiny bit taller then the rear. Looks great

easy to install. lifted the front of my Chevy Silverado a little over 3". The truck looks great very happy with how easy it was to install and how it looks. My brother is getting a kit for his truck after seeing mine.

Leveled my truck with it, did the job and did it well. Had it installed by a shop. I give it 5 stars