1/2" Nylon Stem Bumper, Glides, Floor Protectors for Patio Swivel Chairs, Jejavu, Pack of 25, Black

Works well. There is conflicting info about the required hole size in the "about" and the product "description". One states a 15/64" hole and the other states 1/4" hole. 1/4" is the correct size. The part fits with friction fit in a 1/4" drilled hole. Does not fit in 15/64".

Replacement for the originals on my patio chairs and they fit perfect and popped right in the original holes, good buy!

Just what I needed.

Good product at a great price

These are solid, hard, nylon glides. I have chairs that have 15/64" diameter holes in metal legs in my indoor dining room chairs. These chairs are used on hardwood floors. The holes are measured by putting a 15/32" drill bit into the hole to make sure it fits as recommended by the seller, and it does. The glides had to be hammered into place. Not a problem, as you want them to stay there, but they won't just pop in, so you should be prepared. If the holes were enlarged, then the glides likely would not stay in. I believe these will last a good long while.

These worked great for me. Installation seemed impossible at first. Here is the easy way you do it.Removal: To remove the old worn down pads, drill them out with a small bit, screw in a dry wall screw, and use a claw hammer to pull it like a nail. you may also want to use a block of wood under the claw hammer so you don't mar the chair's finish.Installation: To install,l have the chair sitting in it's normal position. Slide one of the pads under it to align with one of the holes. Smack the chair with dead blow hammer or rubber mallet until the pad is fully seated. You might want use a towel or something between where you hit the mallet and the chair to prevent marring. After several attempts using other methods I found this worked best for me.Good Luck

Measurements misleading.

These bumpers fit the circular swivel beautifully. I love them.