3D Printer Enclosure for Bambu Lab A1 Combo/A1 Mini Combo with AMS Lite,840X570X570mm Enclosure Large Size Fireproof Dustproof Tent Constant Temperature Protective Cover

Works just as intended. Good quality. Easy setup.

While it works, it doesn't leave enough space in front of and behind the bed for it to move it's full range without the cable hitting the enclosure in the rear, and the bed hitting it in the front. While this hasn't caused any noticeable issues for me so far, I imagine this could cause some serious problems in certain circumstances.Quality is good enough overall, but the top has no center support and sags internally. The bowden tubes running between the AMS Lite and the hub will be permanently rubbing against the top of the enclosure unless you brace it somehow. I used some cheap 1/2" pine lath and just measured and cut it to sit secure on top of the frame. Mounted an EvaDry rechargable desiccant with motion activated led ring light to it as well.I enjoy the pockets and appreciate the included hygrometer. It was also very easy to assemble.

I love this enclosure! I have my printer on the floor and this protects it from anything that might get kicked around. I love the pockets for my silica gel packs to keep the humidity down. The LED indicator for temp and humidity is a great touch. Highly recommend

Got this for a Bambu A1 Combo so that I could keep it in the garage without it getting filthy. Putting it together was super easy, even before I realized it came with instructions. The front opening is plenty to work in when setting up the printer and it has a side opening for changing out filament on the AMS without fully opening the front.The only down side is the cheapo thermometer/hygrometer it comes with. The thermometer reads low and the hygrometer reads excessively high. It's usually sitting in the 70-80% range despite other hygrometers reading 40-50%. Obviously that's not good with a 3d printer enclosure since you want to monitor humidity to ensure your filament isn't ruined or ruining your print. I'd recommend buying a different hygrometer to monitor your enclosure. You can find bluetooth or wifi enabled ones for really cheap so it's worth it to find a better one than try to rely on this thing.

The wrinkles in the clear view area make the product unsightly.It is misleading to show pictures where these viewports are nice and flat.Note that for the Bambu Labs A1, the depth of the enclosure leaves zero clearance. That is it is an exact fit front to back if the enclosure is zipped up. But it does work!

It seems to be doing the job. I got it to try to control some of the moisture in the air from being absorbed by the filament of the 3-D printer. It literally took me 5 minutes to put together. The printer and AMS have plenty of room inside the tent. I may be able to even fit a small dehumidifier in there with the printer, right now I’m using silica gel desiccant packs which the tent has 3 pockets inside for. Over all its a good buy. I would of like to seen a built in led strip for light but I can always do that myself later.

The product’s fiberglass frame poses significant safety risks. The fibers easily shed, causing skin irritation and are difficult to remove. Inhalation of these particles can lead to irreversible lung damage. Without proper protective measures, this product is not recommended.

Works great for my A1 with AMS top mount. The hygrometer is nice but this tent helps regulate heat inside and keeps the fumes contained which is exactly what I was looking for.