SONOFFZBMINIL2 Extreme Zigbee Smart Light Switch (2 Way), Compatible with Alexa, SmartThings Hub, Google Home&SONOFF ZBBridge-P, ZigBee Hub Required, No Neutral Required 4-Pack

Easy installation, and it is good for 220 volts. Works well with my Alexa.

easy to add to z2m in home assistant. use these to control various lights in my house. no neutral means they'll work in more wiring situations but you don't get routing/repeating or energy monitoring. trade-off is they are very compact and function flawlessly. very occasional flicker with led lights but that may be an issue with my house vs the relays

I got the ZBMINIL2 to modify a switch in my house that is wired out to the flood light off my garage. There is no neutral in the light switch box so this was the easier solution then trying to get that wire redone or trying to wire a smart switch up out there that would still get a signal all the way from the house.It works well for this and is small enough to fit in the box with a normal light switch installed too.A few things to be aware of.-It does not work well with light switches that illuminate when the light should be off. I had just reused the switch I had installed here already but I ended up having to switch this out for a normal light switch as it was causing it to not receive commands from the Zigbee hub (Hubitat C7).-The slots where the wires connect are very shallow and extremely close together. I had to trim down the wires I had which could be an issue in the future if I switch this back to a normal light switch only as the wires in this box were already pretty short. The slots are the screw type where you tighten the tiny screw to clamp the wire in and these never really feel that secure. Mine is also installed in a metal box so having exposed wire that close to the edge of a device that might slip out is pretty concerning but the wires don't really move once it is installed so there really isn't any reason for them to work themselves out.

House was built in the 60's and there's no neutral ran to some of the light switches. These are a great alternative to the Kasa switches I usually like to use that require a neutral. Home Assistant picked them right up.

These are terrible. I had a four pack of ZBMINI before this and they worked great until this week when one failed (they fail ON by the way). This product ZBMINIL2 seemed to be the new version that was available when I ordered them.I had neutral available, but wired it per instructions. Wouldn't pair. Had to pair them on a bench with a cord and a lamp. Installed them and they appeared to work. Totally unreliable. Work only a small percentage of the time I try to control them from the smart hub (hubitat). They don't work at all with certain LED lights. I SWAPPED FIXTURES to try and make these work better. Still works less than 1/4 the time. One stopped connecting at all and appeared dead. The other three are installed but can't be used as a smart device.I did order the ZBMINIR2 to replace these, but wish I could get my money back.

Should be standard in every home. Work great with the hub and google home. Never any connection issues like some other brands.

It is perfect for old 2wire switch wiring without neutral in the switchbox. Very small, and can fit inside a standard 1Gang box with a standard thin toggle switch. Fatter paddle switches might not fit. Has a relay, so it makes an audible click when switching.No neutral needed. Without neutral this model does not act as repeater. This is an zigbee endpoint device and no special driver needed for smartthings.Range is shorter than most of my other zigbee devices, even when outside of an electrical box hanging free-air.

Easy to install, works awesome. Meets all my expectations.