TechSol 5 Pack of Black Universal Speaker Wall Brackets

Great product! Ordered before 12 mid-day and was delivered by 6pm. Installed the following day and can say they do exactly what I needed. Easy to install and made of what looks like hardened plastic. Can only swivel around 90 degrees and around 30 degrees but pretty good if positioned well.

Really good speaker brackets.

Good value for money, easily mounted with supplied fixings, however the supplied bolts to fit your speaker to the bracket were too small, they supply M5 bolts and my speakers required M6 bolts. Not a big issue as I had some lying about, I also had to drill the bolt holes to accept the M6 bolts, again not a big deal. Also I drilled a 6mm hole on the bottom half of the brackets to run the speaker cable through as there is no cable management on these brackets. So bear that in mind if you don't want any visible cables, there are brackets available with cable management though.

Fixing included are for brick walls so I had to use some plasterboard plugs on one of the walls, but apart from that easy to screw onto the speakers and nice range of adjustment for lining up the speakers.

Purchased these to mount Logitech Z906 THX speakers - The speakers have a standard mount screw hole, the M5 screws supplied with these mounts do not fit. Also as with most satellite speakers the mount hole is not far from the speaker wire connectors, the part attached to the speaker covers the speaker connections so as to possibly press and release the cable. As i had to source screws/bolts anyway to fit the Z906 speakers , i used washers and nuts to raise the mount plate away from the speaker cable connectors. Other than the poor positioning design of the plate that fits to speakers , these a basically solid adjustable mounts. Not bad but not great.

Got all 5 speaker brackets installed in my living room (DIY). They do the job perfectly holding my SONY 5.1 Home Cinema System speakers.On the downside, SONY speakers have got only one screw hole on their back, so the speaker can theoretically rotate on the wall bracket. I used a second set of small screws to hack straight into the plastic body of the SONY speaker through the bracket holes. It worked well.I am enjoying the work well done for over a year!!! Nice design!!!You almost do not see the brackets behind the speakers.

These look OK but I can't see how I'm supposed to fix them,the back covers the wires so the speakers can't sit flat.

I required an item that held up my five loudspeakers. This item was the perfect match for what I was looking for. Looking at the build quality, it was superb. The item came with five bags that featured the screws and wall plugs required to install the mounts, all you needed was a drill. This enabled me to put up the mounts without requiring any more resources. I highly recommend this item.