DUSKTEC LED Driver 12V 30W, LED Transformer AC 240V to DC 12 Volt 2.5A, Low Voltage Power Supply Constant Voltage for Strip Lights MR16 GU5.3 MR11 GU4 Bulbs G4 Spotlights

Good little machine

replacement works fine

Bought 30 units in two deliveries, 2 units did not work for some reason. Very happy with other units, easy to install and worked fine.

I needed a replacement 12v transformer for my LED strip lights but I couldn't find an identical one for my JS25-1202500. Instead I searched for a rewireable unit which I could cut and splice my existing light fitting connections into and I came across this one on Amazon that had the same 12v 30w rating. I was unsure at first whether a transformer and LED driver were the same thing, but a quick internet search assured me both were the same, just given different names.This unit is a similar size to the original unit and as it sits on top of the kitchen cupboards it is hidden from view.It was a simple procedure to wire in my existing connections and the transformer is clearly labelled with the input 240v and 12v output to avoid any confusion. Beneath each of the green terminal covers are 2 connections, again clearly labelled live and neutral so even someone with little to no electrical knowledge or skills should be able to replace their faulty transformer. Just remember to turn off the mains power the particular power circuit is on first, if in doubt consult or get a professional or qualified electrician.I managed to replace this transformer in far less time than I spent looking for a like for like replacement and at under £10 saved me a fortune in either replacing the complete LED light strips or getting an electrician out to fix the problem.

A perfect replacement LED driver for refrigeration display LED lighting systems, these transformers are available in several different output wattages so you should be able to match the wattage of your faulty driver, have not had any issues with them and some have been in service for a while.

I am happy with this LED transformer, it was smaller than expected, I needed it to replace a transformer that powered ME16 halogen lights. I was advised to swap the halogen for LEDS by an electrician but the original transformer didn’t work with them. My concern was that because the lights were switched by a motion controller and I have had issues in the past using LEDS in that configuration, anyway this setup works great.

ABSOLUTE TRASH !BEWARE !!! WIRE UP THE SUPPLY SIDE FIRST AND CHECK THE VOLTAGE BEFORE CONNECTING THE LOAD !I have had 3 now that all initially start out with the correct voltage for a few seconds then fail and just supply mains voltage to your delicate electronics and poof ! wrecked them cheap Chinese junk. Go for a better brand

Works fine as a led driver, but strain relief is useless (which is a concern on the mains side).