ElecGear 8X ALPS 10K Replacement Potentiometer + Drift Fix PCB for PS4, Xbox, Elite, Switch Pro Wireless Controllers, Trim Pot Resistor Thumbstick Module Sensor for ALPS Analog Joystick

It worked! Grabbed these just for the potentiometer disks. Did not have to solder anything. Just swapped out the potentiometers for drift issue. Ended up swapping out all 4 even though was only on left stick. No drift on either side and works like new. Recommend to anyone with stick drift

These potentiometers looks almost as long as the original ones. No complains at all.

Fixed 2 broken controllers with these bad boys. Nice

Replaced just the inside sensor from this at first. Didn't work. Soldered in two for two different controllers and both work great so far. Might update if they fail soon. Walmart xbox one x controllers.

Remember to recalibrate with the xbox accessories app when done.

I don't normally leave reviews, but this is my 2nd time purchasing these 10k potentiometers from ElecGear. The first set I got was to replace on Dualsense and Xbox controllers. About half of these are junk. Measuring with a multimeter, you will get a variance value of anywhere between 8.9kohms to 9.5komhs. While that value is normal, its not until you install these on a controller that you notice a lot of noise and resistance spikes. My second kit, I tried all of these on a Dualshock Thumbstick with and without 1.8v applied and when pressed in the directions, resistance is all over the place. ± 150-200kohms. Not a single pot in this kit went back to the the values it should be. Pressing on the left axis, Not a single pot went close to 0v. The best I could i get was 0.5-0.9. Pressing on the right axis, Not single one of these pots made it within 1.8v. The best pot only reached 1.53v when the right axis was pressed in all the way. I'm actually starting to think these are not real alps potentiometers. Ive never had so much issue with pots in my life. Aside from all of the horrible values, the noise on these is really bad. Noise that causes resistance value changes at rest between 150-220kohms. I will never be buying these again. Spend a little more and get some better pots.

These potentiometers fixed the drift and range of motion issues my Elite Series 2 controller developed after several years of use. Installation is not the easiest if you are new to soldering, but it is possible to do with soldering iron and solder wick.

These did not fix my issue with stick drift, however they did reduce the amount of stick drift.