dracaena.io 6 pack G1/4" thread to 14mm outer diameter, Hard Tubing Compression Fitting with high body design for Computer water cooling system, Black

These fittings are cheap, look good, and work great. I used them in my most recent system and they look and work well. No leaks.

I purchased fittings from 6 different manufacturers and these are by far the best out of all of them. most of them are very hard to get the tube into due to the tightness of the oring, this sucks when you are working with tight fits and delicate hardware. The dracena are easy to insert the tube into and the 3 oring design makes it air tight. I tested all of the fittings with a leak testing pump way above the limit for 24 hours and these did not leak a bit

They are a really great build quality and work fantastic and the fact they are cheaper priced than the name brand only makes it better

These fittings have been rock solid in my build. Due to stocking issues, I am running a mixture of the 3 O-Ring 14mm fittings and the 2 O-ring fittings. Both are showing no signs of leakage when monitoring my Leakshield and the finish stayed perfectly intact while I was assembling my setup and they look fantastic. Never buying overpriced fittings again.

These have held up better than expected. Leaves a clean look and most importantly has not leaked. Comes with extra gasket rings in case you accidentally tear any.

Loved these fittings for my pc watercool build. They work better than a lot of lower cost fittings. I loved that they have multiple seals which help lock the cooling tubes in place snug.

Great fittings especially for the price. Don’t go spend $20 per fitting buy these they are honestly great 0 issues with them.

Needed some of these for my new water loop and pump setup in my PC and they were exactly what I needed. 10/10

Used them in a lot of my build . Quality good as always.

サイズ間違えて注文しました、外形１６㎜が欲しかった。

Failed high pressure test and slipped off hard tube above 12PSI. Passed low pressure testing at 4.5PSI. Only seals with one oring in fitting and one compression seal which I found not very snug. I would not recommend this for high end builds with complex loops and expensive components. If you are trying to watercool on a budget and are okay knowing that it might be fine at lower pressures then go on ahead as the alternative options will be much more expensive.

Raccordi molto ben fatti E prezzo decisamente onesto!

水もれなく 作りもしっかりしていて、水冷PCには必需品です。ありがとうございました。