Zwickey Black Diamond Delta Broadhead 170 gr 2 Blade

Would have had more impressive results had I aimed an inch to the left. Still, for a 15 yard shot with 45 lb recurve limbs the performance is undeniable. Use 4" x4 helical feather fletching so spins quite well in fight. Just take special care when sharpening: there is a slight change in angle halfway up the blade.Update: Early November 2018 harvested a buck at 9 yards. The head performed quite well with a complete pass through when sent from the recurve. The deer expired in under 10 seconds.

Shot this beast from 30 yrd mark straight into a steel dumpster with RX -1 turbo set at 60 lbs and flying on a wal-mart wolverine arrow flew tad high n right but cut right through .3/4 of a inch buried into that steel box . Took pliers to get it out and not barely a scratch on the broad head. Not a bend either.These will not fail .Just have to tune to the shaft n the bow . Once ya know where they fly ,its all over for target

Good penetration. Tough. Easy to pull out of targets. High grade steel. Can't be beat for the money.

Arrived with large bur on edge. Not sharp at all which is fine if they would at least stay intact. Broke the first one by simply threading it into the arrow. Head became separated from threads now it sticks out 1/8” and rotates freely. The other two sharpened up well and are ok.

Not as sharp as I remember

Shot these out of my recurve and they fly kinda funky and are extremely breakable

great broadhead

Fly decent with my 4-fletch shield cut feathers. Are built ok for light/medium use but are basically 2 pieces of steel stamped together. Probably won't take too much abuse. Biggest problem is that the edge is garbage. See attached pic. Right out of the packaging the edge was rounded over and they are a bear to sharpen. Steel is soft and won't hold an edge. Had to put it on the bench grinder just to clean the factory edge up and try to put a new one on. I won't be buying again.