HC37GE210A - Upgraded Replacement Condenser Fan Motor Fits Payne 1/5 HP 230 Volts

Worked perfectly.

My 15 year units needed new fans. I replaced two units and immediately there was a noticeable drop in temperature. The AC Unit could easily reach cooler temperatures faster. WHY? because this fan actually keeps the compressor cooler. It makes the refrigerant more efficient since the refrigerant can get cooler faster since the compressor will run so much better with a new fan. Its that simple. A 15 year old fan in the florida sun means those bearings, and electrical wiring that is constantly running is struggling to spin. Even if it works it can run better.One negative, is that the wiring doesn't have much slack, but it fits I didn't need to do cut or measure. It can easily be installed. The fan fit perfectly. Also make sure you get zip ties. You will need zip ties to make sure the wiring is taut. So buy some zip ties too. Also when you install make sure the power is completely off. that means the ac unit inside and outside.

Works well, cable a bit too shortThis need a 5uF caps not a 7.5uF like in the picture.Otherwise does the jobs

Yes the wires are to short like everyone says but all you need to do is drill a new hole to relocate where the wires come though ten min fix works great

This motor works beautifully, and actually better than the original fan motor. It was not hard to install, although as many have said, the lead wires are shorter than they should be. But, otherwise, no complaints.

We installed the part and our AC worked for about two weeks and then stopped working again. We then replaced two other items on the AC unit but it still didn't work. We replaced the motor again with a new part and all is better. The first part was bad but we couldn't get a refund because it took over a month to figure out the problem

I bought this motor as a direct replacement for my original Payne condenser motor. It fit perfectly, including the correct wiring, EXCEPT the motor shaft was about 3/4 inch shorter than the original. So, in order to ensure the cooling blades would not contact the motor housing, I tweaked each blade at their base with Vise-Grips. No biggie, it only took a minute or two. It was worth the trouble to save $275 vs OEM pricing. Mine was made in Mexico, which I'm okay with. Had it been from China? I would have returned it, fast.

I don't know why they did this, but the yellow and the brown wires were much shorter than the black wire. I ended up drilling a 1/2 inch hole towards the top of my AC condenser unit so that the wires would reach their components. The three wires on this new fan motor were of a smaller gage than the original motor wires and there were no mounting nuts included. I took 2 stars off this rating for that. If not for the short wires issue, this fan motor installation would have been easy and quick. The fan motor works fine now.