Electric Fuel Pump E8016S

Worked for its intended purpose

I purchased one a few months back. It fueling a Baja bug with a mildly built 92x74 with dual 34 epc carburetors. It has about 9000 miles on it so far. I think this pump is a good choice for those into aftermarket tinkering.

My car didn't start, now it does. Used it on nissan with triple webers. While it turned out to just be a wire short that caused me to push the car home, this got the job done. I put my old (and much higher quality) mitsuba back on, but this would have been fine. Cheap and and it works. Also worth noting, it is MUCH quieter than my mitsuba.

I installed this in my 1953 Willys 4x4 wagon. My fuel pump went out and due to the installation it is impossible to replace without essentially pulling the engine. Purchased this and was back on the road in less than an hour. Installation was straight forward and the unit seems very well made. So far works great! Just make sure you note the pressure and that it matches the required pressure for your application.

Thought I would try something like this one just to save a few bucks. Should have known when I open the box and no markings or labeling whatsoever, no QC marking, no instructions, nothing. Just the parts in the bare box. At first it ran for 90 seconds then dies. Not hooked up to carb or anthing on output side, just running fuel in a bucket. Even then I was only able to get five or six times running out of it while verifying voltage etc. Purchased 9/13 and today is 10/18 so it looks like I'm beyond Amazon return window. Chinese junk wins again. Do not risk it guys, stick with a Facet pump or something from Jegs or Summit

Just the right part that I needed

Pumps good fittings are cheap

Using this as a replacement for a golf cart gasoline engine fuel pump where low pressure fuel supply is required. Works as advertised.

Thanks for completing this order ,all parts are perfect .