5pcs 10mm AC/DC 12-24V LED Metal Indicator Light Waterproof Signal Lamp Pilot Dash Directional Car Truck Boat with Wire

Ther work well. can run on 12 or 24 volt. seem nice and bright on 24 volts. can handle AC or DC volts, and as such it makes no difference which way you connect them. Holding out well so far. Good value.

Great Product Great Price Works Great

Worked great for our 2019 Cherokee Latitude. Used some black hot glue and made a wiring harness and following the hood release cable.

Nice but not bright enough. Small and works on 120V incredible.

Husband here... These were lovely, and cheap too. Worked as advertised for 220v application, installed a baseboard heater + thermostat where neither had an "on" light (to my surprise). Very easy to drill 5/8" hole in baseboard faceplate, install light (comes with O-ring + back nut), add to wirenuts, works fine for many hours already.

Perfect for what I needed. The indicator light on my deep freezer broke. This light fit just right. It was easy to hook up. It looks great and the price was right.

These LED lights look to be good quality. They are perfect for my application. Fairly bright but look good.

Pleasantly surprised. I got these to put on the side wall of my folks well house to indicate when the thermal switch for the dealer turns on. That way, they don't have to go outside to make sure the heater is on when it gets cold inside the well house. I can't speak to how long it lasts, but I can say that for such a small light, it is plenty bright to be seen from inside the house, night or day.

Bonne visibilité de l'éclairage, qualité de l'ensemble pas mal pour le tarif

små och snygga

Tested the Gebildet 5pcs 10mm AC/DC 12-24V LED Metal Indicator .... RED version The good news is it's well finished, comes with the required mounting nut, Red+ Black wires of about 140mm length and is viewable from a very wide range of angles. On test it does indeed work on 12v and 24V It's at 24V DC that it reached maximum brightness In my test that was drawing 15mA and about 0.4Watts At 12V the figures were 7mA and 0.08 Watts At 8V that was 5mA and 0.04 Watts, still very visible but with a steady decline continuing to about 2.5V where it dimmed a lot . . (Note these figures will only hold for the Red 12/24V version) In short everything you'd expect from (I guess) a Red 1.8V LED in a neat package with a resistor of around 1.5 K ohms As mentioned above the light level is very good at 12 or 24V, Even at 12V it can be dazzling if looked at directly. For indoor use at around 12V I tried adding another 10K of resistance in the positive lead and it was still very useably bright with the current now reduced to around 1mA as a bonus Good product and reasonable value for money

Colis reçus ce soir correspond a mes attentes et fonctionne parfaitement

Kwaliteit top