Primus IQ

Zero issues with the controller, was probably the easiest installation I've done given my Ford had all the wiring tucked behind the driver side left kick panel, literally. NOTE: this only applies if you have the trailer tow package pre-installed from the factory, if you don't the wires may not be provisioned and additional wiring may be required. Always check with the mfg of the tow vehicle and the RV dealer. I simply had to pop off the panel and the wire was there, the only thing I did was pull it up into the wiring area just below the dash, mounted the controller with the hardware there above my left knee (some say don't do it in the event of an accident, I'm going against that due to accidents will provide you with other issues), and it's far enough away and to the left I can fully see it and I don't want to be looking at it after it's set up for my trailer. Set up of the controller ..took all of 7-minutes (3min to read the instructions), after the trailer is hooked up, adjust the amount of signal being sent to the trailer brakes, do a pull test and adjust/set. These are now pretty straight forward but if you don't want to install it when you buy your trailer/RV, the dealer can do it for about $50-$100 ish. Tekonsha has been in the business of brake controller and other electronics for years, sure there are others but when it comes to stopping, I trust this brand.

He cambiado un Hopkins por el tekonsha y mejoro bastante, excelente compra

Installed on a 2021 F150 XLT. Works as it should with great, easy to use adjustability. Been using Tekonsha products for years and they've never let me down. During transit, the wiring on my trailer wore a hole and split a couple wires. The unit alerted me to the issue. I repaired the wiring and away we went. Much better peace of mind than an analog unit. The only issue I had was where to mount it. You need to consider this before purchase. The screen is only viewable from above the unit. If mounted at an angle on the lower dash, understand you may not be able to see the screen.

Pretty cool product, I’ve used for approximately 5 tows so far and it works nicely. I like being able to pinch the side button and activate the trailer brakes only. The different boost levels are obviously calibrated properly, after testing. Very pleased so far - exactly what I needed.

Install was simple and instructions are clear and install took about 45 minutes with the wiring harness that is made for my truck. Tested on my cargo trailer and it works great. I highly recommend this controller