Skyjacker CA50 Pitman Arm for 2.5" - 4" Lift

used this on my 4" lifted 1975 chevy k10. worked well. quality part. i dont have cross over steering yet, so this is doing a nice job until i upgrade later down the road. bump steer isnt that bad with this at all in my setup

good

This is exactly what I needed to fix the bump steer on my K5 Blazer with a 4" lift and 35" tires. For a 4" lift, DO NOT RUN THE RAISED STEERING ARM! Buy this instead! The raised steering arm causes bump steer. This Dropped pitman arm places the drag link at the same angle as the lift leaf springs which allows them to move together.

Good

Worked out great. Bought another also.

I'm sure that the sector shaft in my steering box is a splined shaft all the way around. I was just confused when I took this part out of the box and saw that the mounting hole was only splined over a certain section.I was also a bit disappointed in the fact that it required a nut and bolt to lock it into place and the part did not come with one.

Well, my factory pitman arm stripped, and left me stranded. I found out the hard way there are no replacements local at any parts stores, and found this on Amazon. My truck has a pretty serious lift, 40x18x15 tires, and never steered well since I got it. This part helped tremendously with steering response as soon as I put it on, and I would recommend the steering arm that goes with it if you truck has a pretty decent lift. I would buy this product over and over again instead of investing in the one piece steering assembly. It allows me to buy local parts instead as they wear out and still maintains proper steering angle. I am very happy with this purchase, and it is cheaper here by about $20, even with overnight shipping.

I used this on my 87 K5 Blazer that has a 2 inch Rough Country lift. Before installing this drop pitman arm, the truck would wander and had some bump and brake steer. The drop pitman arm gets the drag link back to the original factory angle which elminates those problems. Very happy with the result.