KegWorks 1 x Heavy Duty Beer Faucet & Hex Nut Wrench

It works perfectly for the set up I am currently using!

Needed to clean and replace my beer faucets needed a wrench to disassemble and have them cleaned. Found this product to be very helpful at a extremely reasonable price. Saved on gas saved on time ordered from home and delivered on time. recommend find this from Amazon.

The pointed spanner hook slips out of the hole entirely too easily. It is pointed rather than flat like 99% of other spanners. If I’d paid better attention when I was buying it I’d have passed. To make matters worse the sellers does not allow returns on the useless piece of garbage they sell. AVOID THIS.

Feels like a quality wrench for its purpose. This is a must have for a kegorator. The faucet spanner works great and the hex wrench side allows me to tighten down the beer line. Remember that all kegroator setups are different. Some people complain the the wrench side does not fit anything in their setup. In my case I have a home made keezer built from an older chest freezer for my homebrew. The 1 inch hex wrench fits on one of the three different sized nuts inside. Even if you cant use the hex wrench side the faucet spanner alone is worth the purchase.

Spanner wrench side works great on my beer faucets. The wrench side is not useful for my setup. The wrench is too big for the swivel nuts on ball lock/pin lock connections for corny kegs. The wrench is too small for loosening the brass nut on my 5lb CO2 tank. I think that the wrench is intended for the nut that goes on top of a sanke coupler and I imagine that it does the job. My bad for not reading the description properly. Just be aware that if you are looking for a spanner wrench for a homebrew setup, you can find a cheaper spanner wrench that will do a good job.

Haven't used it yet but looks and feels solid - a simple tool that I'm fairly certain will work just fine.

This was a backup unit for one I received in a kit. I wasn't sure of the quality of the one I was going to receive so I bought this as an extra. It is heavy and good quality. Works great!

There seems to but 2 models.I didn't receive the one pictured but it is the same model number.One doesn't have plastic on the handle as long as the other and there is a difference in the thickness of the handle.I received what I am guessing is a newer model with longer plastic to help prevent marring.The wrench end is for a particular type of nut on the back of an extension tube not for tightening the tap in.Whether this wrench works is dependent on yhe tap you own.It does the job on one tap but not a great fit on my other but works okishThey are different brand taps.Overall I would rate it soso 3/5