PowerbuiltCoil Spring Compressor Tool Kit, 5 Piece, Straight or Curved Coil Springs, Shock Absorbers, Foreign and Domestic, Storage Case - 648603, Black

Ha llegado antes de lo previsto, es perfecto Justo lo que se pidió.

Didn’t exactly work for my job, but that wasn’t the tools fault. Fairly solidly built, and for the price it will be nice to have around for the next job.

I used this to install front coil springs in your typical GM RWD 2WD application. I quickly.found the threaded was going to be way too long and would protrude too far on the top side and hit the frame. As such I cut 4-1/2 inches off the rod and it was good. The arms on this compressor are also not offset enough to allow the tool to be parallel inside the spring, it does work but this makes it cumbersome. I had to compress my spring from 14 inches down to about 10 inches on order to install it with the lower control arm hanging off the spindle. Be sure and double sure your seated on the top into the frame pocket a d that the spring is clock properly into the lower control arm. This is tricky and cumbersome as well. Dont plan to install springs in this manner into a show quality painted frame without damaging the paint its impossible! I used the rubber insulators and if I had to do it again I think I might pre glue them to the spring with weather strip adhesive. They do not stay put! I much prefer to this job on a vehicle I am not trying to restore nicely where you have the weight of the engine and a floor jack to get these springs in. Long post I know but these are my observations and I hope to prevent you some of these frustrations!!

Worked jut fine.

Works as should. Heavy duty.