LANZARAmplifier Car Audio, 2 Channel, 1,000 Watt, 4 Ohm, MOSFET, RCA Input, Bass Boost, Mobile Audio, Amplifier for Car Speakers, Car Electronics, Crossover Network (HTG237)

After about a year of wrecking this amp at full volume with a 12” pioneer speaker and bass enclosure every single day I can happily say , it’s a very well made amplifier.The amplifier is very well made and really worth the money. It puts out a serious amount of power. Recommend this amplifier to anyone looking to power a single 12” speaker and doesent want to spend much money. I bought it originally for €75.

Buon prodotto, piccolo, poco ingombro.Peccato che in estate soffra molto la temperatura, ma è comprensibile

No hace bien el corte de frecuencia para los bajos y metía distorcion , aparte de que tenía roto el switch selector de corte. No lo recomiendo

Arrived on time via Amazon shipping/Prime. Amp is well protected in the OEM packaging. Included are four mounting screws/washers, an extra 25A fuse & Lanzar/Pyle manual/literature. This is a two channel stereo amp, but it can be bridged to as low as 4 Ohms load. It will handle as low as a 2 Ohm load on its left/right speaker channels. It has a fixed (not adjustable) High Pass (treble) crossover & a variable (adjustable) Low Pass (bass) crossover. Furthermore, it has a variable bass adjustment & gain control. I have the amp bridged to a pair of these:Planet Audio DVC 4 Ohm AC10D 10 inch subwooferI have pair of the above listed subwoofers wired in series (each speaker wired to 8 Ohms), which equals a 4 Ohm load to the bridged amp. They sound good after some bass/gain/crossover adjustments. I set the amp to LP (bass only) & have a second amp plugged into the outputs of the Lanzar/Pyle amp powering two tweeters. Why I deducted two stars:1- Only way this amp would produce 1000 watts @ 4 Ohms bridged would be if lightning struck it2- ***DANGEROUS design flaw. On the bottom side of this amp are ventilation holes for heat dissipation; however when you mount the amp to any solid flat surface they ALL are blocked . This allows the amp get extremely HOT quickly! This is a fire hazard and will also dramatically shorten the life of the amp too. I had four 1/2 inch thick hardened plastic spacers left over from a HDTV wall mount kit, which I put under the amp between it & the mounting surface, so the ventilation holes are not blocked.. Furthermore I mounted a 135mm computer power supply fan to the top of this amp.3- No variable high pass crossover adjustment (fixed)I strongly advise you to read the second complaint listed above before considering purchasing this amp. If you are looking for an amp to power some low-medium wattage sub woofers/woofers and make sure you get the HEAT under control this will suit your needs. For my needs it is a keeper, but just barely.

As stated in headline. this is a 12v device. and does NOT have a large voltage range as stated in the description.using this with 24v (which is what the rest of my equipment uses fine) resulted in blowing an internal capacitor after less than 5 minutes of testing. the capacitor blown was the left channel 35v 2200uf capacitor.this issue alone is why I'm rating this 1 star.to ever change/edit my review I'd need a replacement and a change to the product description to very clearly state the voltage ratings of the device. device voltage should have been clearly stated as a limit, not just vaguely mentioned with unspecific information