Rear License Plate Holder Base Mount Bracket Compatible with BMW 1/2/3/4/5/6 Series X1 X3 X4 X5 X6 Z4, Replacement for 51187160607 511882380615 Tag Frame Holder Trunk Mount Adapter

This license plate holder was exactly, and I mean EXACTLY, like the one that came on my 2012 BMW 328 Coupe.

Worked out well for my BMW x3. It replaced the factory mount that went missing without issue. All hardware needed was included and I especially like that they’ve used torx style screws for greater theft deterrence.

Easy swap replacement on my BMW X7. Holes matched perfectly. The holes for the license plate are threaded instead of requiring self-threading screws. Makes for a much easier and cleaner installation.

Perfect fit for my BMW Z4. Screw length just right not to poke holes in the bumper.

I lowered this review to a 4/5 stars because it works great and is cheap. But it isn’t a great long term solution if you plan to ever remove the plate. But it’s cheap so just buy a new one PURCHASED 8/20/2024 The product fit my 2015 m235xi (f22) perfectly. All the screws and wrench were included but I replaced them with Phillips head screws for convenience. The bracket itself felt and looked exactly like the original from the manufacturer UPDATE AS OF 4/8/26 The hardware on the bracket rusted solid. One retainer cracked with the torque of a hand screwdriver. The second screw I tried actually broke the tip of the screwdriver! Luckily, if this happens to you, you can bend the edges of the plate and unscrew the mount directly from the vechile itself without removing any of the 4 license screws.

Nice product, reasonably priced. Wish it came with stainless screws. After few years on the car, all screws get rusted and difficult to remove.

Nice clean license plate that comes with hex screws and the key for it. Very simple to set up and fast shipping! Worked for my 2003 BMW 330i Sedan

This worked great for what I needed.

Arrived without mounting hardware.

Excellent product. Fits our 2024 BMW i4 M50 perfectly and is much better than the bracket from the factory. If you are installing a thick protective license plate cover, you will need longer screws than what comes with it. Our plate cover needed 16mm M5 screws to attach correctly.

No felt or rubber pads on the rear. Screws supplied were incorrect & did not fit license plate properly. Screws were also too long so even if used, would protrude into the rear of the trunk itself causing damage to the paint over time. Plastic was very cheap & flimsy as well.

It's not right square and not really fit. I think it's low quality