(4 Pack) PGN 5/8" x 1-3/8" Flanged Ball Bearing - Replacement for Lawnmower Wheels - Chrome Steel - Lubricated

I found myself needing to fix my sister's wheelchair. Thanks to YouTube and this product, I got the job done, and I feel quite proud of that fact. You are now my go-to if I ever need to replace ball bearings on another wheelchair.

I was really impressed with the seals and the heft of the bearings. Heavy and thick, very tight rotation meaning no slap back and forth so good tolerance controls. Smooth rotation.Had to get this to replace a failed bearing for my tracer ex2 wheelchair caster fork which made it extremely difficult to turn or swivel. Had ordered the bearings that amazon listed as correct for my wheelchair (also purchased from Amazon) but those bearings were not big enough. If your inside diameter is 5/8 inch and the cross width is 1 and 3/8 inches for the bearing body and the lip or flange is about 1 and half inches then this should work for you too. I was so impressed with this bearing i went ahead and replaced the other 3 bearings in my wheelchair even though they were still working you could feel they had a little give back and forth. Now my wheelchair is smooth and so easy to maneuver. It's described as being used in minibikes and lawnmower and I believe this bearing will perform very well for that. So I wholeheartedly recommend this product. The other bearings I ordered weren't as quality made as these were but their biggest problem was that it would not work even though the manufacturer pdf parts list says it should work for most models with the note to verify actual fit. Those were 1/2 inch inside diameter and only 1 and 1/8 inches across the bearing. Hope this helps someone else.Good day

Had some pressure washer wheels that the bearings were worn out, new wheel assemblies was gonna cost 50 bucks, spent 10 bucks and got brand new bearings. 10 minute install. Nice tight fit couldn’t ask for a better quick fix for an old pressure washer wheels . I bought many bearings from PNG , different bearings over the years and they’ve always been suitable for what I need them for

These bearings are a perfect fit for the Zero Turn, Kubota Z121s KH-48 Kommander. I used them to replace worn bearings on the front wheel axles. I would say they are an adequate product for the price. I expect they will last 4 years and 400 operating hours. I would buy them again.

Good fit for skag freedom z mower front wheel

I use them in the wheels for my pressure washer. They seem like they should be good.

A+ Product A+ seller

bearing worked fine. only thing i will say is to carefully remove the plastic bearing seals on both sides with the tip of a utility blade. wash out the clear whatever type grease it is with carb cleaner, brake clean or parts cleaner.. i repacked with high quality synthetic grease. wipe off the extra grease. then just pop the covers back on. also be careful when driving the bearings in. i first tried a socket with extension and the lip of the bearing cracked. tossed it away then used another with a bearing driver tool. its just the bearing is so small and the outer race is very thin. once in they work great.