Fluke TP88 Rigid Back Probe Pin Set, 2" Length

Great tool. Should have purchased these years ago.

Well made probes

These are *very* sharp pin probes which attach onto standard 2mm test lead metal probe tips. The attachment is a friction fit, without threading, so care is needed to prevent pulling the probe out of the TP88. I use these tips with a set of TP175E probes, and they work great for hitting fine traces on circuit boards and for probing connector shells. If your boards are conformal coated, this will go right through the coating to give a good reading.One thing to keep in mind is that these tips are only rated for 60VDC. For typical uses this is plenty, but always keep in mind what the voltage you are measuring could be.

For getting into tight places they are great.

Great for the price, would purchase again. After a bit of use the sheathing will slide off the pins continuously. They have a protective cover you can place back on after use.

They work great, and they're nice and sharp. The only thing I dislike is how long they are, if I could find some just like these but short, they'd be perfect.

Have been using these for a few years, and they are great for small pins. Spend the money on good ones. I bought a cheap imitation set, will not do that again, get the real ones like this.

These are very high quality. Kinda pricey I guess for what you get but they are very well made. Nice small sharp pointy tip good for back probing or piercing wires. The shaft is rubber coated to prevent crossing them and shorting something out. I use them with my power probe 3 a lot