sourcing map Adjustable Tap Wrench Handle, for Metric M6-M14 Taps, Thread Tap Holder Reamer Hand Tapping Tool for Machinist Repair, Die-Casting Body

This is nicely engineered and works well. It is a vast improvement over the awful, cheap holders that are included with most budget tap sets. In comparison to the 'normal' cheap ones, it is a pleasure to use and excellent value for money.

This tap wrench is suitable for light weight DIY/emergency small gauge thread cutting. It's not really an industrial tool as I don't consider it's quality or durability is up to repetitive or constant use. It's OK for cutting threads in aluminium and probably light/ thin sections of mild steel. It's difficult to get a very firm grip on the locking thread and consequently taps tend to work loose or rotate in the clamping jaws and drop out and/or get stuck in the material. I used it to recut 10 threads in sheet aluminium with little trouble, but I think this is probably the limit of its usefulness due to the problems noted above.Solidly manufactured for occasional use.

I bought this to replace a rather poor one that came in a set. This is much much better quality.

The description said die cast body but in fact it is made from steel throughout.Threaded handle is slightly sloppy but tightens fine.Time will tell how durable it is but it is leagues better than the normal cheap zinc alloy bodied type often supplied in kits.

Feels sturdy, there were a few sharp edges (including a bit of swarf from the tapped hole for the handle) that needed cleaning up before it could be used safely.The straightness is accptable for larger taps but it doesnt hold the tap square enough for smaller m1-m3 taps for easy operation. Very small taps (m2.5 and below) are difficult to clamp hard enough to stop them working loose.In short I would only reccomend this for very occasional use, if you need a tap wrench with any frequency then get something better.

I work as a machinist so these see quite a bit of regular use for tapping parts and was surprised how well made they were when I got them for the price!The whole thing is made from machined steel not cast so it's very strong and the machining quality is quite decent for the price, it holds onto taps really well! Recommended

Very happy with this. Its made tapping anything over M6 soooooo much wasier than thewrench that came with tap set. Wish I!d bought it ages ago.

Meets all needs given by the manufacturer, quality is good for the price.

Compared to the other tap handles, which are made of some cheap pot metal, this one is actually rather well machined from steel.It gives a good clamping force and stays clamped. So far, so good. It will probably last.

Super produit pour tarauder exellente qualité

schweres, robustes Werkzeug, das seinen Zweck erfüllt

Qualität lässt zu wünschen übrig.

Hat prima geklappt und seinen Zweck erfüllt.