Jeremywell Industrial Professional Pipe & Tube Notcher Punch and Press Tool for 0-50 Degree Angle, Heavy Duty, Notches 3/4" - 3" Round Tubing Bore Hole

So far using it, I’m impressed. Better than the first cheap one I bought . Built tough thick material easy setup . Instructions could be slightly better but once you figure out the everything less than 15 minutes to setup. Would be nice if it had its own mount along with just mount into the vise . For price and quality of what you get I’d by it again compared to other should’ve just bought this in the first place

Ok got this via FedEx, they had the box mangled up by the time I received it, and it was missing the bit spindle making it useless. I got hold of the vendor letting him know the situation, instead of sending a new spindle, they sent me a whole new notcher and spindle within 3 days. Great customer service not to mention the heavy duty quality of this product I had over 60 notches to make in 1 inch round tube and it really made short work of it. All in all I'm happy with the Company for there fast response to the problem and the quality of the notcher, well worth the price.

The vertical zero mark is not accurate, but easy enough to re-index, and you don’t need shims to do it since it’s designed to enable offsets. Angle scale seems pretty close, but I check with a protractor anyway. Tube holder seems to work well, wish it coverd a length of tube equal to the backstop. I think a C-clamp and piece of angle could do. After a dozen or so miters the arbor is getting a little play, but the bearing block is removable so I think a better system than needle bearings could be fabricated. Happy so far with 0.035” wall tubes and fine tooth hole saws. Not mill rigid, but way better than the bottom tier notchers and improvements seem easy to make.

This notcher works great! I have used it on many projects already and it’s held up. I highly recommend it if your on the fence. One of the best additions to my fabrication tools.

The arbor is not the one shown on Amazon, nor the instruction manual. Even with a low profile hole saw, the blade extended past the backing plate of the pipe clamp, rendering the product unusable. Product also came with extra hex screws that did not belong to the product. Hopefully the replacement they send me has the correct parts so I can leave a positive review. Everything else about the product seemed like it was good quality. Update: The replacement had the same arbor. DO NOT BUY THIS PRODUCT!

The threaded adapter for standard hole saws was cross threaded in production, so I couldn't use it until I got another one. I called the seller and he sounded like he didn't think that I knew what I was doing. He did agree to send me the needed part. He never did send it. So I bought one at the hardware store. Also, it cuts off center so they didn't do the math correctly when they engineered it.

I've been notching 1.5" NPS sched 40 with it. Have made about a dozen cuts so far and no issues. I do recommend thread lock on all bolts as they tend to vibrate loose.

I purchased 2 of the vevor pipe notchers both were junk. The Jeremywell Industrial Professional Pipe notcher. Is by far better. Th only difference is this one you can't do offset notches.