Replacement drive belt for Delta Table Saw 34-670 34-674 36-600 36-610 TS300

I followed the instructions that I found on line. 1. Retracted blade and turned the saw upside down. 2. Tilted the motor to 45-deg. 3. Removed plastic cover by loosening 4 Phillips screws, which stayed captured. 4. Ordered belt. 5. After receiving belt, loosened screw on motor drive and was careful to capture screw. 6. Wiggled new belt onto large and small pulleys through rotation; took about 10 minutes. 7. Replaced screws from steps 3. and 5. 8. Unrotated blade and put saw upright. Voila. Worked for me.

works\fits well

I have the Delta 34-670, 120V, 5500 RPM motor, and sure enough this belt fits and got the blade to turn without slipping. Good so far.

Most of these are being given as Christmas gifts

Works as expected

Took a little while to get. But it was what I heeded

Fit perfectly, has been very durable even under heavy load

It works!