GASPRO 29 x 13 Inch Glass Wind Guard for Rectangular Fire Pit Table, Thick and Sturdy Tempered Glass Panel with Hard Aluminum Corner Bracket & Rubber Feet, Easy to Assemble

Very well made. Fits on my fire table just fine. Only if side glasses are made to 9 inches would be perfect,rubber feet seats on a firepit frame but it's not burning. I wonder if they sells spacers.

Surprisingly easy to put together.

This is a great product...very heavy tempered glass that does its job. A beautiful and necessary accessory for a fire table. One small suggestion: the hardware bag came open on my unit during shipping but luckily all the parts that fell out of the bag simply fell into the shipping box. The tape on one end of the box was torn so if the box had been shipped/delivered with the other end up, I would have lost some of the parts. A simple redesign of the hardware bag should fix this problem. Overall a terrific product, well worth its price.

If you are reading this then I don't need to tell you what this does right? So let's get right to it then. The tempered glass panels are thick and free of distortions. I'd say they're about 7mm thick. This thing isn't a light weight and should hold up well outdoors. The size fit our fire pit perfectly with about an inch gap all the way around the gas tray. There are rubber feet to raise the glass about a quarter of an inch thus allowing air to feed the flames. Since glass and metal brackets don't bend, assembly can be a little tricky especially if some of the sand casted brackets a slightly out of spec. Make sure each bracket is facing the correct way, as four have threading for the feet and four do not. My recommendation is to finger tighten each screw leaving some wiggle room to get the last glass panel on. I had to use a little WD-40 to get it to slip onto place. Once it's all together, then I proceeded to tighten snugly no over do it, the screws. Install the feet and you are ready to go.

Put on our table fire place. Helps block the wind. We put a plastic lid over it sloping slightly, then the furniture cover. Otherwise, it fills up with rain.

This is a really nice item. The glass is thick and beveled. The quality is definitely there. The difficulty comes in two places of the assembly. First: The rubber feet. You have to use the screw to poke holes in the bottom of the rubber. So it's conical (cone-shaped). Put the screw into the opening thread first. Then push it through the rubber. Then screw it into the brackets. Second: The glass. I assembled per the instructions. Too tight, couldn't get the last glass piece in. I removed all the screws to keep the brackets loose and still could not get the last glass piece in. I finally disassembled everything and reassembled in a different order (different brackets in different places). This time, when I put the screws in, I just inserted them to make sure the glass was seated properly in the brackets - no tightening. THIS time, the glass pieces and brackets all fit together with little issue. THEN I tightened all the screws. Hope this helps the next person trying to assemble this. Obey the instructions about not forcing the glass too hard. Just disassemble and reassemble after switching bracket positions. Might have to do this a couple times, but at some point it will all fit together (albeit snugly). Then you will be happy with the item, it is very sturdy and is of good quality.

Purchased a new patio set that came with a propane fire pit. The biggest issues were the wind knocking the flames down and the kids hands getting too close to the flames. This wind guard is well built, easy to assemble, and solves our two biggest issues. We can enjoy the fire pit even when it’s windy out and we have the peace of mind knowing the kids aren’t going to burn themselves by accident.

Perfect for my fire table, and pretty easy to put together.

Easy to assemble. Quite heavy so stays in place during windy conditions

I asked a friend about this item. He bought it and did his research prior to buying. His conclusion was that this item is equal in quality to the OEM factory item but 1/2 the price. Now that I have it, I concur. This windshield is very solidly constructed and looks very professional. It looks like it will last forever. Very happy. If only more items were this well made and this well priced. Few are. This is a Gem.

It fit perfectly! Strong and very attractive!

The glass screen arrived quickly and was packed well & easy to put together. I was disappointed to find a scratch in one of the glass panes however. Hopefully it be too obvious when in use or I will need to send it back.

Looks good.