Amazon Basics 1/2 Inch Drive Click Torque Wrench, 20-150 ft.-lb, 27.1-203.5 Nm

Easy to use - just rotate the bottom to adjust the torque setting you require from the ratchet. Nice and solid looking, and done the job for changing my front suspension! Remember to buy a 1/2" to 3/8" or 1/4" if you need to use smaller sockets, otherwise all good!

Good quality and works well

I have NO idea how to use a torque wrench. It appeared simple enough. Initially, it seemed to click all the time, so I couldn't determine when the correct torque had been achieved. After YouTube "how-to" vids, I realised that I need to tighten the wrench when setting the torque, which may be why it seemed to click continuously(??). Saying that, after this revelation, the one click I think I hear is not very audible, so I have to hope that this is correct and just in case, attempt to tighten with a manual wrench too. Quite good value compared to most others I've seen.

OK for the price. Good fit to 1/2” sockets. Simple usual adjustment for torque. I did verify the torque applied using 1m rod @ Kg pull scale and it is accurate with 5%. Supplied with neat plastic case, with rear wall screw head mount if required

worked well so far over the past few months. nice and shiny

Perfect

although not being the most expensive item it is solid enough at almost 1.3 kgs. the instructions are easy to read and understand. calibrated in both foot/pounds and newton/metres. having used this item i can confirm that it works a treat. no more of not being sure if my wheel studs are at the correct torque. i need my glasses on to read the calibrations but that's just me!!

Good value tool that does the job as it should. However I'm deducting two stars as one of the NM readings is actually incorrect - when set to 50 LB/FT, the NM measurement on the handle reads 57.8 NM, but this should actually read 67.8 per the correct unit conversion. No doubt this is likely a simple error caused by someone hitting a 5 instead of 6 on their keyboard when setting up the tooling for the wrench handle - but this simple error could cause a bolt, nut or stud to fail with potentially drastic & costly consequences if not spotted by the user. In my case I needed to set to exactly 50lbft/67.8nm for my cylinder head nuts, and had I not double checked and identified the error when reading the NM measurements, I could've risked overtightening a nut, snapped a stud, and had to spend hours dismantling my engine in order to fix the problem.

Günstige Alternative zu Markenprodukten wenn man nur ab und zu mal ein solches Werkzeug benötigt. Ich hab das Drehmoment mit einem Markenschlüssel überprüft und es scheint zu stimmen. Dank der mitgelieferten Schachtel verstaubt der Schlüssel auch nicht in der Werkzeug, wirkt professionell.

ممتاز

La clé est robuste, avec une très bonne prise en main. Le réglage du couple est facile et le cliquet est précis. Je recommande pour un usage personnel.

Useful and nice,

届いたときの包装が緩衝材が入っていてそのなかにカッコいいケースがあって、その中にはキラキラしていて重いものが入っていました。 金属の重さで8割位原価あるんじゃないか？みたいな Amazonの文字も入っていてヨーロッパの伝説の武器みたいです。殴られたらヤバイですね タイヤ交換するために買いました。在庫がなくて1ヶ月以上待ちました。けど届いたときの感動がすごかったですね。使い心地はまだやってないのでわかりませんが 買いですね