Mini Drill Press Vise Clamp Table Bench Vice for Jewelry Nuclear Clip On DIY Carving Tool Flat Clamp

I use this to hold small parts that I'm engraving on my 3018 CNC. It's good for light duty use but I wouldn't mill with it. The jaws are not parallel and the powder coating inside the jaws just make it more slippery.

For drilling small jewelry pieces. This became my most needed. I was saying to my wife this morning how much I was happy with this purchase

Pretty dang good for its cost. Made of solid aluminum cast, tapped with rough screw holes. Clamps well and had mount holes for bolts to secure to a table or bench.

Good little tool for the low price!

Not a bad little vice, good for light work. Can't seem to tighten part well when using the yellow clamps but overall worth the money.

I bought this to clamp down round items while drilling in a press. It will not clamp on much of anything very tightly. The little plastic tabs that come in contact with your work piece are pretty flimsy. I was not very impressed. However, you get what you pay for and this didn't cost very much.

I can't screw it, although I used some WD40. I would rather spend more money to buy a better one.

It held my new watch in place while I used the hammer and a tiny nail to push the metal pins through the watch links! You’ll need a cloth in between the jaws so as not to scratch your metal band though.