mxuteuk 2pcs 22mm 2 NC Red Mushroom Emergency Stop Push Button Switch AC 660V 10A, 1 Year Warranty HB2-ES544

I got this for my table saw. The on/off switch is on the lower left side which is awkward stutting off with my right hand while holding the work piece with my left hand. I've worked with industrial machinery in the past and they always had an E STOP button that was easily accessible. I mounted this switch on a bracket on the right side of the saw bench where it was safely accessible. I used an old extention coard and cut off about 18 inches of the female end. Both male and female cut ends were feed through the strain relief and connected to the switch. The male end was connected to the power source and the saw was plugged into the female end. Much safer than the way it was.

We have used a few of these on projects. They work well and the price cant be beat. We have yet to have any issues with them. I will continue to buy them as needed for jobs we have going on.

Met my needs and expectations

I took it all apart to tighten the switch body since it was loose when it arrived. What I found was there is no position notch which is normally found in this type of button.Other than that, works as expected.These are not what I would call industrial grade or heavy duty. They are low cost buttons that cost like they are made.

Works great. Same as the one we are Replacing

Tested the switch and it functioned well within the specified specification of 10 amps.

Glad I bought 2. Lost some small parts in the first one. Here are the directions. Unscrew the 2 bolts holding the switches in place, they are easy to remove. Look at the bottom where the switches are attached. There is one area to deform the plastic using needle nose plyers. Press the plastic together with the needle nose plyers and pry off the base. You do not have to remove the red button or button screw (that is where the small parts are located). Reassemble, the base can be pressed on, just line the slots up, etc. and then screw the switches back. Max panel thickness is about 1/8" if you are using the yellow label supplied.Good Luck

Hola, estos botones cumplen con las condiciones descritas en la reseña