1-2-Both-Off Battery Switch 12V-60V Battery Disconnect Master Cut Shut Off for Marine Boat Car RV ATV Vehicle Heavy Duty Battery Isolator Switch

No it’s not a Blue Sea or Perko but it does its job well for my application. I wanted to add a 12 volt dc light over my sump pit, using the sump pump battery. I have the sump backup pump and light wired through this switch. Now for the boat I would recommend paying for the Blue Sea or Perko battery switch. They are simply built better, you do get what you pay for here. The terminals are close enough together that it would be hard to route number fours and heavier gauge wires to this switch. You would have route them from at least two different directions, if not three, as this switch is considerably smaller than the other brands I have mentioned. 5 Stars for this application, for a boat where you need reliability and such, just buy a BlueSea or Perko switch.

Installed in Cat skid steer to isolate battery + terminal. Working well. Need to make sure cable terminals stay separated with shrink material or liquid insulation. Well made. May require making a mounting plate and drilling some holes to firmly attach it to vehicle frame.

Planned a 2 battery switching system for quite some time for obvious reasons. These switches can get terribly expensive. When I found this price it was time to complete the project. I didn't mount it where it would be in the weather. Just seemed like a bad idea. I can see where a dashboard mount would be convenient but I mounted it inside the battery covers under and enclosure so weather will not an issue. Lift the lid switch the battery on, no big deal. It is a heavy A/B/A+B/ OFF rotary switch. The connection bolts appear to be stainless steel so corrosion shouldn't be an issue, I coat them with dielectric grease anyway. This is the same heavy duty switch sold in the marine stores for way more money.

Being much smaller than the conventional marine cut off switch it provides flexibility of installation locations. Don’t be fooled by its size it works the same as the big units.

Appears well built, hooked up two seperate lifepo4 24v banks, can switch all off or use bank 1 or bank 2 as well as combine both with flip of switch.

The switch is exactly what I wanted. I was replacing an existing where the prior switch would not connect to two batteries. The hardware supplied was good stainless machine screws. I used 5/16 ring connectors on the battery cables which had plenty of room on the lugs of the switch.

Works as it should

divided my batteries up and now i can feel safe i always have a back up battery just in case.