100 Pack Zip Tie Adhesive Mounts Self Adhesive Cable Tie Base Holders with Multi-Purpose Cable Tie (Length 150 mm, Width 2 cm, White)

Every thing was as expected. We were putting up under counter lights all around the kitchem.The ty wraos and these holder made thinstallationquick, easy and professional,l Big kitchen, lots of under cabinet lighting.These holders and ties were the same color as the wires and cabinets.Dave M, Winter Haven, FL

I have been searching and trying multiple products for my electric window candles. The weight from the cord kept pulling my candles down. The adhesive sticks great and the tie wrap secures my candles in place. I have actually placed them to the baseboard to keep wires from my electronics neat and not a trip hazard.

I find uses for these all the time. Recently I used them to wind-stabilize a Christmas wreath that we hung on the side of the house. I hung it from wire from the top, but used these on the sides and bottom to keep it from rocking in the wind.These are pretty good ones. As with any zip tie anchor, they could be a little stickier, but if you clean the surface with an alcohol swab, they adhere pretty well.Be sure to buy a set of black ones too. I find different colors useful depending on where I’m putting them.

These adhesive strips helped me to easily guide cords around my classroom. I loved how the white made everything look so much cleaner and condensed.I did see what the others were taking about with the adhesive not sticking. You cannot pull Long thick wires very hard / tight along the mounts... If so you will need to put the mounts more frequently along the cord. Elsewise, for standard cords and use they were great!

I use these things everywhere! These little guys are great for all kinds of hanging wire and cord management. I was able to use them all over the ceiling in my garage for cord management, they worked amazingly! However, just like other things that have a rigid backing to them with adhesive, they do not stick to bumpy/raised surfaces very well but this is to be expected. I tried to do some wire management behind my TV that is hanging above my fireplace that is brick but it does not stick to the changing surface very well. other than that these things are great!

Hello everyone. I wanted to get my old VR system set back up. After a short realization that I have cats, I needed to get my sensors to the wall. I bought wall-mounts and these to hold loose cables, and I was a little overzealous. Now my wall looks great but I cant get the cable ties off! To be specific: trying and prying these with my fingers I couldn't pop them off. I followed the instructions pretty closely during installation, cleaning the surface, holding and pressing the cable ties for about 30 seconds.So for me, they've worked wonders, I just need to wander around the internet to find an adequate way of getting these off.

Okay product. Some of the adhesives aren't great- not sure if it's a quality control issue. We used these to hang up a pretty small wire (nothing thick/heavy) to a small speaker and after a week or so it popped off. Others have stayed in place for several months.

These are a good buy for the job. The only minor issue is the glue seems to also face the zip tie opening so when tightening the zip tie it may be a bit of a challenge getting that last little bit as it fights the grip of the glue against the tie. It will go though with some patience. The adhesion itself is tremendous. Warning: where you decide to place these will be a lifetime commitment.