NEW MDS33059401 SealPro Compatible Washer Door Boot Seal for LG Washer PS3535198 AP4445815, 1370944, by SealPro - 1 YEAR WARRANTY

This gasket fits my LG WM2016CW perfectly. At the time of purchase, this seller was 30 dollars cheaper than some others I had seen. The gasket appears to be the same quality and thickness of material as the original. Arrived quickly and in good condition. To start off with I needed a pump and ordered it first. While removing the pump I discovered the gasket and ordered it two days later. The delivery of the gasket beat the pump to my house but arrived same day. If I can pull off the repair of this gasket and the pump, you can too. My only complaint is that the gasket came slightly out of shape from being in the box for a few days, I think. Out of shape in a bad spot at the bottom where it needs to drain. I think I can coax it the other way by placing a light amount of weight on it over time. I am still happy with the gasket and the seller. I wouldn't have purchased it if hadn't found it in this price range. Thank you!

Wasted couple hours of my time just to figure out the seal was damaged… washer still leaks…

Fit and finish like oem that it replaced.

5 Stars for Product Fit and 3 Stars for Product ConditionThe boot fit perfectly for LG WM2016CW. No issues there. It's a little bit of work to get it on there, but compare to replacing the bearings this was fairly easy.The issue I had was after the installation, I notice a little wrinkle and a slight bulge close to the bottom of the boot. Water was gathering and slight droplets from the door seal. I believe this was due to the way the boot were packaged and shipped. If I wasn't so inconvenient, I would send it back for a replacement.

Fit perfect. Had to punch drain hole through rubber. Holding springs difficult to install.

Do some time to get the seal to sit, suggest starting it on the top and then working the final stretch on the bottom. Start project with patience, going to take it in order to work through getting it on well. You will need an extra set of hands at different times during install. Perfect fit for our wm2016cw.

My old boot was not leaking but was ugly with soap grime. Figured 15 year old washer could use a new one. Item came quickly and was packaged okay (others complained came folded up). However the rubber is terribly distorted in areas. I did not attempt to install as I just couldn't see that the boot would straighten out and seal properly....especially at bottom. Removed old boot , soaked and cleaned and reindtalled with no problems. Returning and saving $$.

I'm not sure if it's the build quality of the boot or what, but it feels like a sloppy design of an original mold. The rubber is twisted and... inaccurate in ways that prevent the boot from fitting properly on the inside and outside lips of the washing machine.I've re-seated the boot three times trying to get everything aligned and snug, to no avail. I did NOT have this much trouble with the last boot I replaced, which I believe was an "official" product.This boot will do for now, but I expect it to collect water, moisture and mold in places much faster than our first two. I wouldn't advise getting this one for long-term usage.