Gotical 4 -Pieces Roll Pin Punch Set and with Free Pivot Pin - Pieces Bolt Catch Install for Automotive, Watch Repair,Jewelry and Craft Punch Set - 1/16", 5/64", 3/32", 1/8" W/Roll Pin Install Tool

I read countless reviews worrying about quality and possibly bending any of the roll pin starters, I decided to pull the trigger (pun intended) on this one, I’m glad I did! I had no issues and the quality is great for the price. If you are bending these then you are going too fast and hitting too hard. Go slow and take your time, it shouldn’t require so much force seating pins and if it does then something ain’t right.

I love that this set is compact and precise. Exactly what I was looking for!!

they work just fine and the price was pretty good too.

Again I just finished a custom build and used punches to remove a number of roll pins, however putting them in is a different story, especially if your working with roll pins that are between 1/4" and 1/2" inch long or shorter, I was upgrading the charging handle latch on my nephews AR to an extended AMBI battle latch and removing the pin was the easy part. I don't have big meaty hands and fingers, but trying to hold the latch against the spring and align the holes in the handle housing and the latch wasn't easy and on top of that trying to drive in a tiny roll pin too was almost impossible, after the pin slipping and popping off a few times and eventually flying through the air to unknown locations never to be seen again I ordered a new roll pin and a set of starter punches, when the new pin and starter pin punches arrived I took another stab at it and using these little suckers with the roll pin I was done in 30 seconds and never once did I loose grip of the roll pin or ihad it popped out and go flying through the air, it was the easiest roll pin install I'd ever done so if your working on firearms or anything else that uses roll pins these are a must have, especially if your installing a low profile gas block with shorter then normal gas block roll pins it's even more of a must have tool, yeah they are a little expensive but are worth every penny BC

Awesome tools. Made it very easy to build a AR15

The punch set worked good for the pistol and rifle I was working on.

Looking to save a little time and taping while assembling your sporting rifle? Well look no further... These, once used a few times to loosen up the tolerances, have saved me from having to tape up the lower to drive the bolt catch roll pin in. When used in conjunction with a small brass hammer and an appropriate 3/32 brass punch, this will start the pin and before it bottoms out the guide, it will leave 3/16 to 1/4 to drive the rest of the way in. I have stopped taping up the sides of the lowers during assembly since this eliminated the worry that the standard punch would slip off and scratch the finished surface of the receiver. These starter punches were a great addition to my tool set and were well worth the money. These should last a long time for those who are hobbyists, but those who build an Army's worth of rifles may peen the end over in time.

If you need to set a roll pin in your "Outdoor Tool" these are the best for starting the pin without damage to the pin or "tool" you are installing it in. Prior to getting this I would deform pins trying to get them started. This Tool set makes it easy.