Nilight LED Light Bar 2PCS 18W Flood Off Road Lights 12V 5Pin Rocker Switch Wiring Harness Kit, 2 Years Warranty, Clear,White

Lights are very bright, assembly was not too difficult (however does not come with installation instructions). The wiring harness is a bit too short between the lights, took some maneuvering to get them where I wanted them without pulling wires every time. You have to crimp the wires to the adapters, I used a set of pliers. It does not include the mounting brackets, I got the red ones separately to match my truck. Overall style of the lights and brackets look very clean and modern. I’d have to rate it a 4.5 because the short wires between the lights, however they’d work great on a smaller vehicle or atv. But overall really for the price.

Installed on my 23 gladiator and shine bright! 2 years later still shining!

Got this companies light bars in the back of my truck and on my brush guard. Even put in a rocker switch pannel on my truck from them and a tail light strip. Amazing company

Easy to install, comes with instructions on how to mount, had everything hooked up and working in half hour. Been about 4 months since install and no signs of inner condensation forming on the lights despite rain, pressure washing and heat. Comes with all hardware and wiring, however my wires may be too short. On my 2005 Tacoma, the wire between both ditchlights was stretched to the max in order to reach each side of my hood (with hood light brackets). Managed to extend the wire just enough to fit. Something to note is the hardware WILL RUST. Light pattern is good, decent little lights, no wind noise on freeways, and with minimal grinding you can fit the switch it comes with on blank Tacoma switches on the left side of the steering wheel.

great product easy to install on my can am defender

These are great value for the price. Great visibility for you and any drivers coming at you. I got them mostly so I’m easier to see when I ride, but they definitely increase how much I see when riding in the dark. They have a good system of brackets to adjust their angle, with no loosening observed after several weeks and a few long rides. Together with the relay they draw less than 2 amps which is important on a motorcycle. They don’t look cheap, and are maintaining their appearance so far, points for that. The size is right for my purpose, these can’t be too big for motorcycles, but they are big enough to have good heat dissipation. Nighlight also sells the brackets I used to attach them to my engine protector frame and various lugs for the harness. I appreciate that the electric harness can be very specific, I did not use the switch that came with these lights, rather I tapped the ignition key to operate the relay. But the switch is a nice one, just no room for it on an adventure bike. One improvement would be to include waterproof connectors. On a motorcycle these are necessary if you have to take them off to work on the bike. I had to purchase them separately. However, on a car or something else it would not be necessary.

Very small and discrete and bright

I'm very pleased with this product. This light kit was installed on a 2020 Kawasaki Mule Pro-FXR along with the Nilight 90027B bar clamp kit. This light kit is a great value compared to the Kawasaki OEM light kit. I'm pleased with the amount of light - it lights the cargo area and floods approximately 50 - 75 feet beyond. The rocker switch fit perfectly into an open rocker bay and the only give-away that it's not OEM is that the rocker switch appearance is a little different than the other switches, as you can see from one of the pictures. It is easy for me to overlook given the price of this kit. I had to make three modifications to the wiring harness in this application: (1) Extended one of the light runs by one foot (2) Extended the main harness by five feet so I could run the harness seamlessly through the existing wiring tunnels (3) The Kawasaki side-by-side had an unused pair of accessory bullet plugs behind the dash. The Nilight harness came with spade connectors, so I had to pigtail a male bullet connector with a one foot lead to reach the unused positive accessory connection. I used the battery ground instead of the accessory ground

Iluminación extra de la pickup

Easy to install and very bright

Good lights, easy to fit, came with everything needed to fit

Facial de instalar pero requiero contactar al vendedor pues los faros no encienden

Éclaire très bien . Bonne produits. Parcontre Il manquerais environ 12 pouces de fil car c est très restreint sur la longueur mais cela fonctionne !!!